MENUS AND FUNCTIONS
28 D-303223 PowerMaster-10/30 G2 User's Guide
Additional Information (section B.6)
For detailed instructions on how to select User Settings – refer to section B.1 and section B.2.
The LED will extinguish after several seconds. In case of difficulties in communication with the control
panel, the LED may blink for several seconds more while trying to establish communication. During this
period of time the keyfob keys are disabled.
The display shows the first enrolled Keyfob (Keyfob No.1) of the 8 keyfobs (PowerMaster-10 G2 / 32 keyfobs
(PowerMaster-30 G2).
To abort enrollment press the button.
If Partition is enabled, continue to step 6 (applicable to PowerMaster-30 G2 only).
You can now enroll another keyfob. You can also select another option in the User Settings menu (see
section B.1 and section B.2), or quit programming (see section B.3).
If the keyfob was previously enrolled in the system, the PowerMaster display reads "
ALREADY
ENROLLED
" and then switches to the name of the keyfob alternating with its ID number.
Before you delete a keyfob, identify the keyfob either by the keyfob No., for example, F06, or by the ID number
of the keyfob that appears on the display, and then make sure that it is the keyfob you wish to delete.
Enrollment by Device ID:
Step 4b enables you to register the device ID and to complete the programming process without being in
possession of the device itself (can also be performed off-site by the installer). Enrollment can then be
completed at a later stage by following the same enrollment procedure described in Step 3 without entering
the User Settings menu.
This setting can be performed only after completing steps 1 - 5 of section B.6A.
The
symbol now appears next to the newly selected Partitions.
You can now repeat steps 2 - 7 to program or edit another keyfob.
To abort the procedure, press the button.
You can now add or delete another keyfob, select another option in the User Settings menu (see section
B.1 and section B.2), or quit programming (see section B.3).
B.7 Setting the Time & Time Format
Here you can program or adjust the built-in-clock to show the correct time in the desired time format.
You can select between a 24 hour and a 12 hour (AM/PM) time format.
Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Set the Time Format
Enter the [USER SETTINGS] menu and select the [TIME & FORMAT] option
and press .
1
The display shows the currently selected time format.
2
Click the or button until the display shows the desired time
format, for example, "EU FORMAT-24H" and press to confirm .
B. To Set the Time
5
At the blinking cursor position, enter the correct time, for example, “8:55A”,
using the numerical keypad.
3
4
When you are satisfied with the setting, press to confirm.
(86 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce