Visonic POWERMASTER-10 - INSTALLER GUIDE Specifikace Strana 65

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 86
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 64
64 D-302756
Enter the second IP receiver telephone number.
33.
34.
You can now press the button to take you to the "
RPRT CNFRM
ALARM
" menu (see section 4.7.3.8), or press the button to take
you to "
<OK> TO EXIT
".
5 DIAGNOSTIC TEST
This mode allows you to test the functionality of all devices of the system and to receive / review information
regarding the received signal strength. Communication between system components can also be tested and
detailed information is reported.
The wireless signal strength measured and reported (see details in the drawing below).
IMPORTANT! Reliable reception must be assured during the initial testing and also throughout subsequent
system maintenance. A device should not be installed in location where signal strength is "poor". If you
get a "poor" signal strength from a certain device, simply re-locate it and re-test until a "good" or "strong" signal
strength is received. This principle should be followed throughout the diagnostic test procedure.
The diagnostic test process is shown below.
5.1 Testing Devices
This section describes how to test or review a device enrolled to the PowerMaster-10 control panel.
Note:
It is much easier to test the device while holding the device in your hand, close to the control panel.
5.1.1 Testing all Devices
1.
Repeat steps 1 to 4 of section 4.2 "Entering the Installer Menu".
2.
3.
4.
(or press the
button for "TEST ONE DEVICE".)
or
The PowerMaster-10 system will now perform automatic testing of all
enrolled devices in the following order: repeaters, sirens, detectors,
keypads.
The PowerMaster-10 system will perform automatic testing of keyfobs (if
enrolled) at the end of testing all other devices.
ACTIVATE NOW Uxx
TEST KEYFOBS NN
TESTING Zxx NNN
TEST ALL DEVICES
WL DEVICES
DIAGNOSTICS
2nd caller ID#
GPRS UP / DOWN
Zobrazit stránku 64
1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 85 86

Komentáře k této Příručce

Žádné komentáře